Connecting A Playback Device; Connecting A Playback Device Using A 3.5 Mm Jack Cable; Using A Cinch Cable - Silvercrest SSTB 10 C2 Operating Instructions And Safety Instructions

Connecting a playback device

You can connect a wide variety of playback devices to this device, for
example MP3 or CD players. Please refer to the operating instructions of the respec-
tive device. Switch off all devices before connecting them.
NOTE
► When playing back music via the AUX connections, the
(
trol are inactive. You can, however, turn the MUTE function on and off using
the button
playback device that you have connected.
► Before starting playback, set a moderate volume. When you reach the
maximum volume, you will hear a signal and the volume can no longer be
increased.
Connecting a playback device using a 3.5 mm jack cable
♦ Connect the line-out connector of the external device (e.g. headphone socket) via
a 3.5 mm jack cable to the AUX 1 socket
♦ To switch on the device, press the
♦ Press the
the remote control repeatedly until
♦ Switch on the connected playback device and start playback.
Connecting a playback device using a cinch cable
♦ Connect the audio input jacks R and L
audio cinch cable with the corresponding audio output sockets on the external
audio device. Make sure that the red and white colour markings correspond.
♦ To switch on the device, press the
♦ Press the
the remote control repeatedly until
♦ Switch on the connected playback device and start playback.
NOTE
► If both the AUX 1 socket
external playback devices, the music will be played back via the AUX 1
socket
3.5 mm jack cable from the AUX 1 socket
■ 32 │ GB │ IE
+ ) and ( +
. Use the Play/Pause and skip functions on the external
/ FUNC. button
/ FUNC. button
and the AUX 2 socket
by default. To use the AUX 2 socket
) buttons on the unit and the remote con-
on the rear of the device.
/ FUNC. button
on the device or the AUX button
appears on the display
on the rear of the device using an
/ FUNC. button
on the device or the AUX button
appears on the display
, simply disconnect the
.
) ,
/ PAIR ( +
or the button .
on
.
or the button .
on
.
are connected to
SSTB 10 C2