Pairing Remotes; Connecting The Module; 8556T Temperature Sensor; 8504D Combo Sensor - Directed DIRECTECHS DS3+ Installation Manual

Pairing Remotes and Sensors
To enter pairing:
1
Turn the vehicle ignition to the ON position.
Within 10 seconds, on the Control Center (antenna) or the LED/Valet Pod
(standalone switch), press and release once (1x), and then press and hold
2
the programming button until the LED starts flashing, then release the button.
* Your antenna may differ from the model shown in the illustration.
Pairing remotes: Follow the remote-specific instructions to complete the pairing process. This information can be found in the RF
kit's owner's guide, "QR2" Tech Tip, and on the DS3/DS4 Quick Reference Install guide.
Pairing sensors: Sensors should be connected to the DS3/DS4 module prior to connecting the 12-pin main power harness.
When powered up, connected peripherals will pair automatically.
In the event where a sensor needs to be re-paired, repeat the steps above. Connected devices will become
registered within 4-6 seconds. No further action is required.

8556T Temperature Sensor

The 8556T Temperature Sensor is optional, but included with your DS3+/DS4+ module.
When used, the Temperature Sensor must be plugged into the 2-pin black connector of your module.
Note: When the system is configured as a remote starter, the temperature is reported by the 8556T Temperature
Sensor. When security features are enabled, it is reported by the 8504D Combo Sensor.

8504D Combo Sensor

The 8504D Combo Sensor is optional, but included with the purchase of a DS4SU security package.
The Combo Sensor is preset for the majority of applications; however, it can be adjusted using the DirectLink
application, as well as a compatible LED or LCD remote. Please refer to the instructions included with the DS4SU for
more information on how to make adjustments.
Note: When the system is configured as a remote starter, the temperature is reported by the 8556T Temperature Sensor.
When security features are enabled, it is reported by the 8504D Combo Sensor.
IMPORTANT:

RF Systems

An RF System consists of one or multiple remotes, a Control Center (antenna), and an antenna cable – various combinations exist. An RF
System allows the vehicle owner to control the system with enhanced range. Two-way models are available. Please follow the instructions
included with the kit for appropriate installation and programming information.
..
When used in conjunction with Directed SmartStart
To enable D2D communication between the DS3+/DS4+ and the Directed SmartStart
before providing power to the Directed SmartStart
SmartStart with Loops – The brown loop must be cut.
SmartStart with Pigtails – The gray wire must be connected to a ground source.
16
933.FORD1 4.22.198.12 2005 Ford Taurus
©2023 Directed. All rights
The Combo Sensor must be paired to the device before it can be used.
®
unit:
®
Key OUT Key IN
START START
& &
Press &
Release
one of the following actions must be performed
®
Key IN Key IN
OR
START START
*
OR
&