Table of Contents
Advertisement
Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
Power Controls
A
B
Figure 1. Power controls.
A. Power Light: Illuminates when motor is
turned ON.
B. Safety Cable Switch: Disables power to
machine when activated. To reset, pull reset
button on safety cable switch until it pops out
(see Figure 20 on Page 18).
C. EMERGENCY STOP Buttons: Each button
disables power to machine when pressed. To
reset, twist button clockwise until it pops out.
-4-
manual
BEFORE
C
F
C
E
D
D. Foot Pedals: When pressed, turn motor ON
and drive rollers to feed workpiece forward or
reverse. When released, rollers stop.
E. Main Power Switch: Turns incoming power
ON or OFF.
ON Button: Turns machine ON.
F.
Main Components
M
L
K
J
Figure 2. Main components.
G. Upper Roller Release Lever: Releases
upper roller from frame for workpiece removal.
H. Rear Roller: Controls bend radius.
I.
Radius Adjustment Handwheel (1 of 2):
Adjusts rear roller up and down for different
sized radius bends.
Thickness Adjustment Knob: Adjusts lower
J.
roller up and down for different workpiece
thicknesses.
K. Lower Roller: Feeds workpiece through
machine.
L.
Upper
Roller:
workpiece against lower roller.
M. Release Lever Lock Knob: Secures upper
roller release lever.
Model G0971 (Mfd. Since 11/23)
G
H
I
Secures
and
presses
Advertisement
Table of Contents
