Advertisement
4. Use the four included M5 x 15 screws to attach the antenna holder to the antenna.
Figure 4 Attaching Antenna Holder to Directional Antenna
Figure 5 Attaching Antenna Holder to Omni Antena
5. Use the two included M6 x 20 screws to fasten the antenna holder to the mount holder. Adjust the antenna
angle by inserting the included M6 x 20 screw into the hole on the mount holder. The antenna can be
adjusted +/-45 degrees vertically. Tighten the screws to a torque of 2.5 N.m.
HPE Aruba Networking AP-ANT-MNT-U Mount Kit | Installation Guide
4
Advertisement
