Table of Contents
Advertisement
(Optional) If your CMA has cable straps, fasten the straps.
8.
Verify the operation of the server rails:
9.
Two people might be needed for this procedure: one to slide the chassis in and out of the server, and the
other to observe the rear panel cables and power cords.
a. Fully extend the chassis out of the server.
b. Check that there is enough slack in the cables and cords for full extension of the chassis. Make sure
that there is no cable binding or crimping.
c. To ensure that the cables and cords are secured properly, slide the chassis in and out of the server.
Make sure that there is no risk of accidental disconnection of the peripheral cables and power cords.
10. Slide the server into the rack until the chassis ears are flushed against the server posts.
11. (Optional) Open the chassis ear latches (callout 1), and then tighten the shipping screws (callout 2).
Hardware options installation
111
Advertisement
Table of Contents
