Ide Hdd Auto Detection; Save And Exit Setup; Exit Without Saving - CHAINTECH CT-6BTM Manual

3-9 IDE HDD Auto Detection

This utility can automatically detect IDE hard disk type and parameters. The detection
process take about 5 seconds for each physical drive. After the utility detects the
disk drive, type Y and press [Enter] to automatically load the parameters in the Hard
Disk section of the Standard CMOS Setup menu. Otherwise, leave the option set
at N and press [Enter] or the [Esc] key to skip the detected drive. After detecting
your hard drive(s), return to the Standard CMOS menu to check your settings.
HARD DISKS
Primary Master
OPTIONS SIZE
2 (Y) 547
1 547
3 547
Note: Some OSes (like SCO-UNIX) must use "NORMAL" for installation

3-10 Save and Exit Setup

If you select this and type Y (for yes) followed by the [Enter] key, the values
entered in the setup utilities will be recorded in the CMOS memory of the BIOS
chip.

3-11 Exit Without Saving

Selecting this option and pressing Y followed by the [Enter] key lets you exit the
Setup program without recording any new values or changing old values.
ROM PCI / ISA BIOS (2A69KC39)
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
TYPE SIZE CYLS
:
Select Primary Master Option (N=Skip) : N
CYLS HEAD
530 32
1060 1 6
530 32
Figure 3-12 IDE HDD Auto Detection Screen
Award BIOS Setup Program
HEAD PRECOMP
PRECOMP LANDZ
0 1059
65535 1059
65535 1059
ESC: Skip
LANDZ SECTOR
SECTOR MODE
63 LBA
63 NORMAL
63 LARGE
MODE
43