Features Setup Page - PCchips M758LMT User Manual

Features Setup Page

This page sets up some parameters for peripheral devices
connected to the system.
AMIBIOS SETUP – FEATURES SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
OnBoard FDC
OnBoard Serial PortA
OnBoard IR Port
OnBoard Parallel Port
Parallel Port Mode
Parallel Port IRQ
Parallel Port DMA
OnBoard PCI IDE
Ultra DMA Support
On Chip Audio
On Chip Modem
OnBoard LAN
USB Function
USB Function For DOS
OnBoard FDC
Use this item to enable or disable the onboard
floppy disk drive interface.
OnBoard Serial
Use this item to enable or disable the onboard
PortA
COM1 serial port, and to assign a port address
OnBoard IR Port
Use this item to define the protocol for an
infrared port if you have installed an optional IR
port. The choices are IrDA and ASKIR.
Onboard Parallel
Use this item to enable or disable the onboard
Port
LPT1 parallel port, and to assign a port
address. The Auto setting will detect and
available address.
Parallel Port Mode
Use this item to set the parallel port mode. You
can select SPP (Standard Parallel Port), ECP
(Extended Capabilities Port), EPP (Enhanced
Parallel Port), or ECP + EPP.
Parallel Port IRQ
Use this item to assign either IRQ 5 or 7 to the
parallel port.
Parallel Port DMA
Use this item to assign a DMA channel to the
parallel port. The options are 0, 1 and 3.
3: BIOS Setup Utility
Enabled
3F8h/COM1
Disabled
378h
EPP+ECP
7
3
Both
ESC : Quit
Disabled
Item
Enabled
F1 : Help
Enabled
Enabled
F5 : Old Values (Shift)F2 : Color
Enabled
F6 : Load BIOS Defaults
Disabled
F7 : Load Setup Defaults
↑↓ ← → : Select
PU/PD/+/ - : Modify
29