Mainboard User's Manual
Install Memory
This mainboard has two DIMM sockets for system memory
modules. You must install at least one memory module in order to
work out this mainboard. You must install the first memory
module in the DIMM1 socket to give shared memory to the
onboard VGA display circuitry.
DIMM1
DIMM2
For this mainboard, you must use 168-pin, 3.3V unbuffered
SDRAM memory modules. If the installed CPU uses a 100MHz
system bus, you must use PC100 or PC133 memory; if a 66MHz
system bus, you must use PC66 memory. You can install any size
memory module from 16 MB to 512MB, so the maximum memory
size is 2 x 512MB = 1GB.
Edge connectors on the memory modules have cut outs coinciding
with spacers in the DIMM sockets that memory modules can only
be installed in the correct orientation.
To install a module, push the retaining latches at either end of the
socket outwards. Position the memory module correctly and insert
it into the DIMM socket. Press the module down into the socket so
that the retaining latches rotate up and secure the module in place
by fitting into notches on the edge of the module.
12