AEG HVB8453IB User Manual page 24

Problem
The indicator above the symbol
comes on.
comes on.
You can hear a constant beep
noise.
- comes on.
- comes on.
- comes on.
- comes on.
- come on.
- come on.
comes on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
24 ENGLISH
Possible cause
Child Safety Device or Lock oper‐
ates.
The flame does not light up in 3 at‐
tempts.
Burner cap or crown are placed in‐
correctly.
Metal part of the flame safety device
is dirty (Refer to "Care and clean‐
ing").
The electrical connection is incor‐
rect.
The hob is too hot.
The hob is overheated.
Temporary condition of failure.
Too many attempts to clear the
warning .
There is an error in the hob.
There is an error in the hob.
There is a dirt around burner area.
The thermocouple of the selected
burner is still too hot to allow the ig‐
nition of the burner to restart.
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
Remedy
Refer to "Child Safety Device" and
"Lock".
To reset the warning
turn on again the hob. When the dis‐
play function reappears, after
light animation, touch
seconds.
When you see the warning is re‐
set.
Disconnect the hob from the electri‐
cal supply. Ask a qualified electri‐
cian to check the installation.
Wait a few minutes for cool down
the hob. If possible, put the large
cookware on the rear burners.
Wait for 30 minutes and follow the
same procedure as if warning
appeared.
If the problem persist, contact an
Authorised Service Centre.
Follow the same procedure as if
warning appeared.
If the problem persist, contact an
Authorised Service Centre.
Wait for 15 minutes.
Follow the same procedure as if
warning appeared.
If the problem persist, contact an
Authorised Service Centre.
Contact an Authorised Service Cen‐
tre.
Disconnect the hob from the electri‐
cal supply for some time. Discon‐
nect the fuse from the electrical sys‐
tem of the house. Connect it again.
If comes on again, speak to an
Authorised Service Centre.
Refer to "Care and cleaning".
Wait for the burner to ignite auto‐
matically.
turn off and
for 3