AEG HVB8453IB User Manual page 15

A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple
E. Pilot flame
5.2 Ignition of the burner
Always light the burner before you put on
the cookware.
WARNING!
Be very careful when you use open fire in
the kitchen environment. The
manufacturer declines any responsibility
in case of the flame misuse.
1. Press and hold
After 50 seconds of non-use, the hob
deactivates.
2. After light animation, when you see
display, press the desired heat setting on
the control bar.
If after some tries the burner does not
light, check if the crown and its cap are in
correct positions .
If during the normal use of the burner it
starts to spark and flame adjust
automatically, check if the metal part of
the ignition candle and the flame safety
device are clean (Refer to "Care and
cleaning").
If the burner accidentally goes out, the
hob re-ignite the burner 3 times. If the
flame still does not light,
to activate the hob.
appears.
If the warning
turn on again the hob. When the display
function reappears, after light
animation, touch
When you see
(Refer to "Troubleshooting").
appears when attempting to restart
the burner immediately after switching off
the flame. Wait for approximately 10
seconds before restarting the burner.
Pilot flame
The flame that surrounds the
thermocouple is a pilot flame. It prevents
unexpected shutdown.
on
5.3 Turning the burner off
To put the flame out, touch the control bar to
the off position
WARNING!
Always turn the flame down or switch it
off before you remove the pans from the
burner.
5.4 Automatic Switch Off
The function deactivates the hob
automatically if:
• all burners are deactivated,
• you do not set the heat setting after you
activate the hob,
appears, turn off and
for 3 seconds.
the warning is reset
.
ENGLISH 15