Elation KL SPOT IP User Manual page 13

G O B O I N S TA L L AT I O N - R O TAT I N G G O B O W H E E L
Locate the Rotating GOBO being replaced. Carefully press the GOBO Holder up to clear the
frame, then pull it out and away until it fully clears the Fixed GOBO Wheel.
Locate the tab of the Retention Spring, and with a precision pick (or similar tool), carefully
press the Retaining Spring inward to relieve the tension. Remove the retaining spring and
carefully separate the GOBO from the GOBO Holder.
CAUTION: TAKE CARE NOT TO SCRATCH GOBO OR GOBO HOLDER
To ensure proper Gobo orientation on the Rotating Gobo Wheel, align the Alignment Dots before
installing the Retention Spring. These alignment dots are the notch in the Gobo Holder, the dot
on the top and bottom of the Gobo Holder Retention Tab, and on the Gobo itself.
Rotate the Gear of the Rotating Gobo Wheel until the Gear Alignment Dot on the Rotating
Gobo Wheel is lined up with the empty Gobo Holder Slot. Install the Gobo Holder Tab into the
Gobo Holder Tab Receptacle and press until the Gobo Holder gently springs into the empty
Gobo Holder Slot.
13