Parrot Uncle BBCF860 Owner's Manual page 9

3. Ceiling Fan Assembly
3.10
Make sure the Grommet is properly installed in the Motor
Coupler Cover, then slide the Motor Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 10).
3.11
Place the Ceiling Cover over the Downrod (Figure 11).
Be sure that the Ceiling Cover and the Motor Coupler
Cover are both oriented correctly (Figure 11).
3.12
Route the Two 80" Motor Wires through the Hanger
Ball (Figure 12).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 12).
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball
(Figure 12).
Loose Set Screw could create Fan wobble.
(Continued)
COUPLER COVER
GROMMET
Figure 10
CEILING COVER
Figure 11
4.5" DOWNROD
PHILLIPS HEAD
SETSCREW
Figure 12
9
4.5" DOWNROD
COUPLER
COVER
4.5" DOWNROD
PIN
HANGER BALL