Advanced Settings - HIKVISION DS-KH6320Y-WTPE2 User Manual

3) Set the synchronizing interval, enter the IP address/domain of NTP server and port No.
Note
The default unit of synchronizing interval is minute.
●
The time zone can be configured as well if the NTP is not enabled.
●
5. Tap to enable Synchronize Time to Door Station to synchronize the device time to the linked
door station.
6. Enable DST and set the DST start time, end time and bias.

3.2.6 Advanced Settings

Device Information
View the device information, including the version, model, serial No. and open source disclaimer.
Steps
1. Tap Settings →
2. View the device version, model, and serial No.
3. Optional: Tap Open Source Disclaimer to view the OSS statement.
Reboot Device
You can reboot the device.
Steps
1. Tap Settings →
2. Tap OK and the device will be rebooted.
Door Station Settings
The indoor station can pair with the main door station.
Steps
1. Tap Settings →
2. Select the device to link. Edit the network parameters by tapping
System Maintenance
You can restore the device, upgrade system, unlink app account, set wizard, and configure security
settings on the system maintenance page.
Tap Settings → → System Maintenance to enter the system maintenance page.
Two-Wire Indoor Station User Manual
→ Device Information to enter the Device Information page.
→ Reboot Device to reboot the indoor station.
→ Main Door Station (D Series) to enter the door station settings page.
12
.