2.2 Mount the Device
Mounting the device on a vertical flat surface.
1. Unscrew the two screws located on the main module.
2. Remove the primary module by pulling it forward off the base module. While separating the
base module from the main module, please use the enclosed accessory handle on the back
of the product, as depicted in the picture.
3. Unscrew the retaining screws located at the base module, and then, remove the back plane
PCB module.
4. Drill two holes 2.24in (56.8mm) vertically apart for 2 x round head M4 screws, using the
separately provided drill template on the ROHS sheet.
Midas S2
13
User Manual