Angelo Decor AD97733 Quick Start Manual

Water Wheel Fountain
We hope you will find these instructions helpful in setting up your product. If you have any issues with this item,
DO NOT return the unit to place of purchase. Please visit our web site www.angelodecor.com for
assistance and warranty information.
Carefully unpack and
arrange all parts.
Pass the tubing down the
opening in the back piece
as shown above.
Lift and lower the wheel on
to the fountain as shown
above.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Place the pump in the
corner as shown. Align the
cord out the back.
Retrieve the tubing from
the base and align it as
shown.
The speed at which the wheel rotates can be adjusted
by tightening or loosing the nuts located on the axle.
Tightening the gap (above left) will slow the rotation
while loosening the gap (above right) will increase the
rotation speed.
Align and lower the back
piece of the fountain in
place.
Connect the tubing to the
pump. Water flow can be
adjusted using the dial on
the front of the pump.
AD97733
Attach the tubing to the
spill arm.
Install the cover plate over
the pump and tubing.
Printed in China