3-13. Enabling/Disabling Sub Pixel Drive
The Sub Pixel Drive can be enabled/disabled.
Attention
• To display in 15 megapixel (15 MsP), software that supports 15 MsP is required.
• When "Sub Pixel Drive" is "On", "Sharpness Recovery" is disabled even if it is set to "On".
Procedure
1. Touch
to turn off the power to the monitor.
2. While holding down the switch at the far left ( ), touch
power to the monitor.
3. Select "Signal Format" from "Administrator Settings", and choose
4. Select "DVI" or "DisplayPort" with
5. Select "Sub Pixel Drive" with
6. Select "On" or "Off" with
7. Select
several times.
8. Select "Apply" with
3-14. Setting the Preferred Refresh Rate of the DVI Signal
The priority of refresh rates can be defined. For the refresh rate, "Low" is set to 25 Hz, and "High" is set to
50 Hz.
Procedure
1. Touch
to turn off the power to the monitor.
2. While holding down the switch at the far left ( ), touch
power to the monitor.
3. Select "Signal Format" from "Administrator Settings", and choose
4. Select "DVI" with
5. Select "Preferred Refresh Rate" with
6. Select "Low" or "High" with
7. Select
several times.
8. Select "Apply" with
14
Chapter 3 Setting the Monitor
or
, and choose
or
, and choose
or
, and choose
or
, and choose
.
or
, and choose
.
or
or
, and choose
or
, and choose
.
for at least two seconds to turn on the
.
.
.
.
for at least two seconds to turn on the
.
, and choose
.
.