Table of Contents
Advertisement
User's Manual
Table 5.5 ADJUST Items and Options
NOTES:
Underlined options are the factory defaults.
When you select less than 1/6IN, please make sure that Print data
from software has enough top margins so that no print data will not
be printed out of paper.
HARDWRE
Options
Items
<FCNTORG>
-1/6 IN
0/6 IN
1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
<FCNTFIN>
0/180, ..., 29/180
<RCNTORG>
-1/6 IN
0/6 IN
1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
<RCNTFIN>
0/180, ..., 29/180
USING SETUP MODE
Description
Sets the top-of-form for front
continuous forms. The top-of-form is
defined distance from top of paper to
bottom of print line. The default is
recommended if your top margin is not
software-specified.
Fine-tunes the top-of-form position for
front continuous forms.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
Sets the top-of-form for rear
continuous forms. The top-of-form is
defined distance from top of paper to
bottom of print line. The default is
recommended if your top margin is not
software-specified.
Fine-tunes the top-of-form position for
rear continuous forms.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
5-35
Advertisement
Table of Contents
