Fujitsu DL7400Pro User Manual page 129

User's Manual
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST Options
Items
<FCNTCUT>
71 /180, 74 /180,
78 /180, 81 /180,
85 /180, 88 /180,
92 /180, 95 /180,
99 /180, 102/180,
106/180, 109/180,
113/180, 116/180,
120/180, 124/180,
128/180, 131/180,
135/180, 138/180,
142/180
<RCNTCUT>
71 /180, 74 /180,
78 /180, 81 /180,
85 /180, 88 /180,
92 /180, 95 /180,
99 /180, 102/180,
106/180, 109/180,
113/180, 116/180,
120/180, 124/180,
128/180, 131/180,
135/180, 138/180,
142/180
<CUT-CUT>
7 /180, 10 /180,
14 /180, 17 /180,
20 /180, 24 /180,
28 /180, 31 /180,
35 /180, 38 /180,
43 /180, 46 /180,
50 /180, 53 /180,
57 /180, 60 /180,
64 /180, 67 /180,
71 /180
<FRCSLNT>
7 /360, 14/360,
21/360, 28/360,
35/360
USING SETUP MODE
Description
It is possible to set the amount of blank
area of both sides of the front continues
form.
This setting is effective only for the
front continues form at <
FCNTARE:ENABLE1 or ENABLE2>
It is possible to set the amount of blank
area of both sides of the back continues
form.
This setting is effective only for the
back continues form at <
RCNTARE:ENABLE1 or ENABLE2>.
It is possible to set the amount of blank
area of both sides of the cut sheet paper.
This setting is effective only for the cut
sheet paper at < CUT-ARE:ENABLE1
or ENABLE2>.
It is possible to set the threshold of
skew detection during manual paper
insertion of a cut sheet.
5-41