Fujitsu DL7400Pro User Manual page 132

USING SETUP MODE
5-44
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Options
Items
<TEARPOS>
VISIBLE
ALWAYS
The following <TEAR-EN> item is printed when TEAROFF:AUTO is
specified for the <TEAROFF> item.
<TEAR-EN>
0 SEC
1 SEC
2 SEC
4 SEC
6 SEC
Description
Tear off position.
Select this option when your software
positions forms to the next top-of
form after printing the last data. The
printer performs tear off feed without
adding a form feed when data transfer
has stopped.
Select this option when your software
stops after printing the last data. The
printer performs tear off feed after
adding a form feed when data transfer
has stopped.
Note: For both settings, tear off
positioning will fail if the page
length setting does not match the
actual perforation spacing.
Tear off enabled time (offset time).
The offset time is from when data
transfer stops to when the printer
performs automatic tear off feed.
If the printer receives data again
within the offset time, the printer
does not perform automatic tear off
feed.
User's Manual