Changing Rear Axle Lubricant; Changing The Bi-Directional Clutch's Lubricant; Fuses - Toro 30631 Operator's Manual

Figure 51
1. Dipstick
2. Groove

Changing Rear Axle Lubricant

After every 400 hours of operation, the oil in the rear
axle must be changed.
1. Position the machine on a level surface.
2. Clean the area around the drain plugs (Fig. 52).
3. Remove the plug allowing the oil to drain into
drain pans.
4. After oil is drained, apply thread-locking
compound on the drain plug threads and
install it in the axle.
5. Fill the axle with lubricant: refer to Checking the
Rear Axle, p 15.
1
Figure 52
1. Drain plugs
Changing the Bi-Directional
Clutch's Lubricant
After every 400 hours of operation, the oil in the bi-
1
2
1
directional clutch must be changed.
1. Position the machine on a level surface.
2. Clean the area around the check plug on the
clutch.
3. Rotate the clutch so the check plug is positioned
downward (Fig 53).
2
1. Clutch
2. Check plug
4. Remove the check plug allowing all lubricant to
flow into the drain pan.
5. Rotate the clutch so the check plug is positioned
at 4:00 O'clock.
6. Add Mobil Fluid 424 until the lubricant level is
up to the hole in the clutch. The clutch should be
approximately
7. Install the check plug.
Note: Do not use engine oil (i.e., 10W30) in the
clutch. Anti-wear and extreme pressure additives will
cause undesirable clutch performance.

Fuses

There are three fuses in the machine's electrical
system, located below control panel.
37
1
Figure 53
1 ⁄ full.
3