Maintenance; Recommended Maintenance Schedule - Toro 30631 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance
Service Interval
After the first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 1000 hours or 2
years, whichever
occurs first
Important
Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Check the power take-off belt tension.
• Check the fan and alternator belt tension.
• Change the transmission filter.
• Torque the wheel lug nuts.
• Change the engine oil filter.
• Check engine RPM.
• Check the battery electrolyte level.
• Check the battery cable connections.
• Lubricate all grease fittings.
• Lubricate the brake cables.
• Check the cutting unit gear box oil level.
• Clean under the cutting unit belt covers.
• Check the cutting unit drive belt adjustment.
• Change the engine oil.
• Inspect the air filter.
• Change the engine oil filter.
• Check the power take-off belt tension.
• Check the fan and alternator belt tension.
• Inspect the cooling system hoses.
• Service the air filter.
• Check rear wheel toe-in and steering linkage.
• Change the transmission filter.
• Torque the wheel lug nuts.
• Drain and clean the fuel tank.
• Replace the cutting unit gear box oil.
• Change the fuel filter.
• Change the fuel/water separator filter.
• Change the rear axle lubricant..
• Adjust valves
• Check engine RPM.
• Replace moving hoses.
• Replace safety switches.
• Flush and replace the coolant system fluid.
• Replace the hydraulic oil.
22