Toro 30631 Operator's Manual page 10

1
3
3
5 5
7
7
1. Power take off on
2. Power take off off
3. Warning—read the operator's manual.
4. Cutting hazard to hands or feet—stay away from rotating
blades and moving parts.
5. Throw object hazard—keep bystanders away.
6. Warning—set the parking brake, stop the engine, and
remove the key before leaving the operator's position.
7. Tipping hazard—when driving down slopes less that 14
degrees, lower the cutting unit to the ground. When
driving down slopes less than 20 degrees, use the roll-
overprotection system, fasten the seat belt, and lower the
cutting unit to the ground.
1. The battery contains lead. Do not throw it in the garbage.
1. Change the hydraulic filter after first 10 operating hours—
read the operator's manual for further instructions.
1
1
1. Danger—read the operator's manual
2. Tipping hazard—when driving down slopes less than 14°, lower
the cutting unit to the ground. When driving down slopes less
than 20°, use the roll-over protection system, fasten the seat
belt, and lower the cutting unit to the ground.
4
4
6
7
93-7806
1
93-6668
1
93-7816
2
2 2
93-7839
1
2
6
1. Hot surface hazard—stay away.
2. Cutting/dismemberment hazard—stay away from moving
parts.
1. Read the operator manual
2. Change the rear axle lubricant initially after the first 50
operating hours; thereafter every 500 hours
1. To move the traction unit forward or backward, depress
the traction pedal.
2. Tipping hazard—when driving down slopes less that 14
degrees, lower the cutting unit to the ground. When
driving down slopes less than 20 degrees, use the roll-
over protections system, fasten the seat belt, and lower
the cutting unit to the ground.
3. Warning—disengage the power take off before raising the
cutting unit.
4. Float cutting unit
5. Lower the cutting unit
6. Raise the cutting unit
10
2
1
100-6574
1
2
93-6697
1
2
2
3
4
93-7832
2
2
3
5
6