Toro 30631 Operator's Manual page 17

lever to move to the TRANSPORT position. The
implement should be raised when driving from one
work area to another, except when descending steep
slopes.
Figure 10
1. Lift lever
CAUTION
The exposed, rotating blades of the cutting unit or
other implements are hazardous.
Never raise a cutting unit or implement while the
blades or other components are rotating.
Power Take Off Lever
The power take-off lever (Fig. 11) has two positions:
ON (engage) and OFF (disengage). Slowly push the
power take-off lever fully forward to the ON position
to start the implement or the cutting unit blades.
Slowly, pull the lever backward to the OFF position to
stop implement operation. The only time the power
take-off lever should be in the ON position is when
the implement or cutting unit is down in operating
position.
Fuel Gauge
The fuel gauge (Fig. 11) indicates quantity of fuel
remaining in the fuel tank.
Hour Meter
The hour meter (Fig. 11) shows the accumulated hours
of engine operation.
1
Oil Pressure Warning Light
The oil pressure warning light (Fig. 11) glows when
oil pressure in the engine drops below a safe level. If
low oil pressure ever occurs, stop the engine and
determine the cause. Repair the damage before
starting the engine again.
Charge Indicator
Illuminates when the system charging circuit
malfunctions (Fig. 11).
Engine Coolant Temperature Warning
Light
The light illuminates and the engine shuts down when
coolant reaches an excessively high temperature
(Fig. 11).
2 3
1
1. Power take-off lever
2. Fuel gauge
3. Hour meter
4. Oil pressure indicator
5. Engine temperature
6. Glow plug indicator
7. Charge indicator
8. Temperature gauge
9. Temperature override switch
10. Key switch
11. Throttle control
12. Battery cover
Temperature Gauge
The temperature gauge (Fig. 11) registers the
temperature of the coolant in the cooling system. If
temperature becomes too high, the engine will shut off
automatically.
17
4 5
7
6
10
11
12
Figure 11
8
9