Toro 30631 Operator's Manual page 7

condition before applying pressure to the system.
• Keep your body and hands away from pin hole
leaks or nozzles that eject hydraulic fluid under
high pressure. Use paper or cardboard, not your
hands, to search for leaks. Hydraulic fluid
escaping under pressure can have sufficient force
to penetrate the skin and cause serious injury.
• Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved by stopping the engine and
lowering the cutting units.
• If the engine must be running to perform a
maintenance adjustment, keep hands, feet,
clothing, and all body parts away from the
cutting units, attachments, power take off shaft,
and any moving parts.
• Do not overspeed the engine by changing
governor settings. To ensure safety and accuracy,
have an authorized Toro distributor check the
maximum engine speed with a tachometer.
Maximum governed engine speed with no load
should be 3200–3250 RPM.
• The engine must be shut off before checking the
oil or adding oil.
• Periodically inspect the roll bar and roll bar
mounting.
Replace, if necessary. Do not modify roll over
protection frames or structures because they are
specifically designed, sized, located, and tested
for injury reduction. If a rollover occurs, a
modified roll-over protection system will not
provide adequate protection.
• If major repairs are ever needed or if assistance is
desired, contact an authorized Toro distributor.
• For optimum performance and continued safety
certification of the machine, use only genuine
Toro replacement parts and accessories.
Replacement parts and accessories made by other
manufacturers could be dangerous, and such use
could void the product warranty.
7