System Requirements; Scope Of Supply - Peak PCAN-Optoadapter User Manual

1.2 System Requirements

The power supply is done via pin 1 of the 9-pin female D-Sub connector (primary
side). Therefore the attached CAN interface must provide 5 Volts.
Since the PCAN-Optoadapter already contains a CAN bus termination on the
primary side, the connected CAN adapter doesn't need to be terminated
separately on this side.

1.3 Scope of Supply

PCAN-Optoadapter in plastic casing
Download
Manual in PDF format
1 Introduction PCAN-Optoadapter
User Manual 4.1.0 © 2023 PEAK-System Technik GmbH
5