BEFORE YOU START Owner's Manual Prior to installation, it is important that you contact your local government authority to determine if building approval is required. Study and understand this owner's manual. Important information and helpful tips will make your construction easier and more enjoyable.
PLAN AHEAD Site Selection Avoid overhanging trees as much as possible as leaves will make regular cleaning necessary and broken branches are a potential hazard. Small trees,bushes or fences nearby can be helpful,acting as a wind break. Site Preparation The site must be prepared so that the base of the shed is level all round and checking The base can be constructed by treated timber or concrete,in order to stop the moisture getting into the shed.The shed is not designed to be built onto lawn directly.Also the...
Page 10
STEP 3 F1 X4 STEP 4 、 When diagonal measurements are equal,the frame is square. 、 The Floor Frame must be BOTH square AND level or the holes will not line up properly.
Page 11
STEP 5 Pay attention to dumping Need a person or a shelf to support. Connect the wall panel to F1 X5 S3 X5 component 4R and the foundation first. STEP 6 Pay attention to dumping Need a person or a shelf to support. F1 X2 S3 X2...
Page 12
STEP 7 Attention: Three hole connection. S3 X2 F1 X2 STEP 8 Pay attention to dumping Need a person or a shelf to support. F1 X2 S3 X2...
Page 14
STEP 11 Pay attention to dumping Need a person or a shelf to support. S3 X2 F1 X2 STEP 12 Pay attention to dumping Need a person or a shelf to support. F1 X2 S3 X2...
Page 15
STEP 13 S3 X2 F1 X2 STEP 14 Pay attention to dumping Need a person or a shelf to support. F1 X2 S3 X2...
Page 16
STEP 15 S3 X2 F1 X2 STEP 16 F1 X2 S3 X2...
Page 17
STEP 17 S3 X2 F1 X2 STEP 18 F1 X2 S3 X2...
Page 18
STEP 19 S3 X2 F1 X2 STEP 20 F1 X6 S3 X6...
Page 19
STEP 21 S3 X6 F1 X6 STEP 22 F1 X24 S3 X24...
Page 20
STEP 23 F1 X30 S3 X30 STEP 24 F1 X36 S3 X36...
Page 21
STEP 25 F2 X4 S3 X4 STEP 26 Pay attention to the orientation of the ventilation window blades. F1 X8...
Page 22
STEP 27 When fixing the porous position, a screw can be used to pass through an accessory first, and then you can use the screw to find the hole position. S3 X8 F1 X8 STEP 28 Please put No.G2 into No.7 F1 X8 S3 X8 Please put No.6 into 4L/4R...
Page 23
STEP 29 Need a ladder to assist with installation. F2 X2 STEP 30 F1 X35 S3 X35...
Page 24
STEP 31 F1 X14 S3 X14 STEP 32 F1 X8 S3 X8...
Page 25
STEP 33 F1 X14 S3 X14 STEP 34 F1 X8 S3 X8...
Page 26
STEP 35 F1 X6 S3 X6 STEP 36 F1 X8 S3 X8...
CARE & SAFETY • Unsuitable for storage of flammable or corrosive substances. • It is of utmost importance to assemble all of the parts according to the directions. Do not skip any step. • Please consult your local authorities if any permits are required to erect shed. •...