HP 1670A Series User Manual page 86

Troubleshooting
Troubleshooting in an MS Windows environment
2 Attempt a remote NFS mount.
Attempt a remote NFS mount of the logic analyzer using File Manager. In the
Disk menu of File Manager, the Network Connections field should appear.
If
this field does not appear, this indicates that the MS Windows-based NFS
software was not properly installed.
Select a Drive Letter under New Connection. If a drive letter does not
appear, then check the LASTDRNE= command
in
the CONFIG.SYS file. The
LASTDRNE= command should be set to a drive letter that would make a
disk drive designation available to use as a drive for the remote file server
while still allowing the last three disk drive designations to be available for
printers. For more information about the CONFIG.SYS file, refer to the
documentation for MS-DOS.
• Normal Response
When Connect is selected, the drive letter and the mounted remote
file server should appear under the Network Drive Connections
window.
• Error Messages
If
error messages appear, then resolve the error messages using your
NFS documentation.
Check to make sure all of the appropriate fields in the Network
Connections menu have the correct information. If all of the fields
have correct information, then refer to your documentation for NFS
and for File Manager for more information.
A Device Busy error message appears when you try to mount as
control if someone else has already mounted as control.
An error message is also received if you try to mount too soon after
power-up. You need to wait at least 15 seconds after the Analyzer
Configuration menu is displayed before attempting to mount.
7-13
I