HP 1670A Series User Manual page 83

Troubleshooting
Troubleshooting in an MS-DOS environment
2 Attempt a remote NFS mount.
Attempt a remote NFS mount of the logic analyzer using the appropriate
command syntax for your NFS software. Refer to the NFS software
documentation for the specific command syntax. The command usually
includes the remote NFS directory (hostname and either the /control or /data
directory) and a disk drive designation.
• Normal Response
The DOS command line prompt should reappear. To verify that the
remote NFS mount was successful, type net use to view the
mounted drives.
• Error Messages
If
an error message appears, check the command syntax before
continuing with the troubleshooting. If the syntax is correct, then
resolve the error message using your network documentation.
Verify that all of the mounting rules are being followed. Refer to the
documentation of your network platform for the mounting rules.
A Device Busy error message appears when you try to mount as
control if someone else has already mounted as control.
Also, if a Device Busy (or similar) error message appears, check the
CONFIG.SYS file for the LASTDRNE= command. The LASTDRIVE=
command should be set to a drive letter that would make a disk drive
designation available to use as a drive for the remote file server while
still allowing the last three disk drive designations to be available for
printers. For more information, refer to the documentation for
MS-DOS.
An error message is also received if you try to mount too soon after
power-up. You need to wait at least 15 seconds after the Analyzer
Configuration menu is displayed before attempting to mount.
7-10