Table of Contents
Advertisement
Fault
The appliance is not
working.
The burner does not
ignite.
The flame for the
oven does not burn
through all outlet
openings.
All dishes prepared in
the oven burn within
a short period of
time.
The fan position is
not working.
The oven switches
off.
The cooling fan is not
working.
The oven lighting is
switched off.
The rotary spit is not
working.
The glass cover
closes quickly
17.2 Replacing the oven light bulb
If the lighting in the cooking compartment fails, change
the oven lamp.
Note: Heat-resistant, 25-watt lamps are available from
the after-sales service or specialist retailers. Only use
these suitable lamps. Hold the new lamps only with a
clean, dry towel. This increases the service life of the
lamp.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
Cause and troubleshooting
There has been a power cut.
Check whether the lighting in your room or other appliances are working.
▶
The safety valve for the gas line is closed.
Open the safety valve for the gas line.
▶
There has been a power cut.
Check whether the lighting in your room or other appliances are working.
▶
The ignition plugs are wet.
Light the gas burner with a gas lighter or a match.
▶
Openings on the burner are soiled.
The burner must be professionally cleaned.
▶
The thermostat is faulty.
Call customer service.
▶
The grill selector is switched on.
Ensure that the grill selector is switched off.
▶
The fan position is not selected.
Ensure that the fan position is switched on.
▶
The gas pressure is too high or too low.
Light the gas burner with a gas lighter or a match.
▶
Incorrect installation.
Call customer service.
▶
Power failure.
Check the oven's power supply.
▶
The cooling fan is faulty.
Call customer service.
▶
The oven light bulb is faulty.
Call customer service.
▶
The rotary spit is not inserted.
Ensure that the rotary spit is inserted correctly.
▶
The rotary spit motor is not working.
Call customer service.
▶
Hinge screws on the lid are loose
Tighten the hinge screws on the right and left sides of the lid.
▶
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You must have a new halogen lamp to replace the
old one.
Place a tea towel in the cooking compartment to
1.
prevent damage.
Troubleshooting en
27
Advertisement
Table of Contents
