NEC DT510 User Manual page 36

Use this
Key for Entering Names
keypad
digit....
# = Accepts an entry (only required if
#
two letters on the same key are
needed – ex: TOM). Pressing # again
= Space.
Conf Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Name).
Clears all the entries from the point of
Exit
the flashing cursor and to the right
(used when entering the Number, this
clears both the number and name).
(8) Press Hold.
(9) Press the Speaker key to hang up.
Line Keys/Programmable Function Keys
The following functions can be assigned to Line Keys if
allowed by Class of Service.
To Program a Line key as a Programmable Function
Key:
(1) Press the Speaker key.
(2) Dial Service Code 751.
(3) Press the Line Key to be programmed.
(4) Dial the code for the desired feature plus
additional data if required.
(5) Press Speaker to hang up.
Note: Service Code 00 will erase the function from the key.
When you want to....
Note: In some cases, the Hold key needs to be pressed
before pressing the Speaker key.
Function
Function
Number
00
Not Defined
01
DSS / One-Touch
Microphone Key
02
(ON/OFF)
03
DND Key
04
BGM (ON/OFF)
05
--Not Used--
06
Transfer Key
07
Conference Key
08
Incoming Call Log
Day/Night Mode
09
Switch
Call Forward –
10
Immediate
11
Call Forward- Busy
Call Forward – No
12
Answer
Call Forward –
13
Busy/No Answer
Call Forward – Both
14
ring
15
Follow Me
16
--Not Used--
17
--Not Used--
30
Additional Data
Extension number or any
numbers (up to 24 digits).
Press HOLD to write.
Mode Number (1-8)