Table of Contents
Advertisement
No editing of DCC tape for
recording.
Possible cause(s)
Cassette tape's accidental
erasure prevent tab is closed.
No digital input recording.
Analog input mode has been
established.
Signal prohibiting the copying
(recording) of digital recordings is
included among input source
signals when digital signals are
supplied.
Troubleshooting Guide
Suggested remedy
Set tab to open position.
Set input selector to proper
position.
Switch to analog input recording.
Digital selection between optical
or coaxial input has not been
performed properly.
Set input selector to proper
position.
Search function does not
operate properly.
Start marker has not been written
properly.
Write start marker.
Track numbers or amount
of play time elapsed is not
displayed properly.
Track numbers have not been
written properly.
Provide running numbers to the
written start markers.
Cassette tape has been loaded
midway through track.
j Press rewind button and rewind to
start of track.
No timer recording or
playback.
Faulty connections.
; Refer to section on connections
and connect properly.
att
Timer has not been programmed
properly.
Check how to operate the timer
again.
Operating remote
controller does not
produce expected results.
No cassetie tape loaded.
| Load cassette tape properly.
Batteries in remote controller
have run down.
Repiace with new batteries.
Signals from remote controller do
not reach deck.
Check both distance between
remote controller and deck and
direction in which controller is
pointed, check that there is
nothing obstructing signal path,
; and operate at correct position.
Advertisement
Table of Contents
