Table of Contents
Advertisement
Timer Playback/Recording
Timer recording occ tapes)
Preparations:
1. Check that the "accidental erasure prevention tab"
on the DCC tape for recording is set to the
recording position. (See page 11.)
=
2. Load the DCC tape for recording. (See page 17.)
Technics
= ara: COMPACT CASSETTE OBCK AE-2C10
1
Select the source to be recorded.
5
TIMER
Set the timer
PLAY
"i
REC
eS
omen
selector to the REC
a
nese?
= Select the input
©)
position.
ANALOG,
OPTICAL
source,
6
Set the timer to the desired time.
The deck's power is now switched off.
.
3
Recs
Set the deck to the
recording standby
When the time set by the timer is reached, the deck's
=
mode.
power is turned on and recording starts automatically.
The auto track number writing mode is established in the
case of timer recording.
Leave the power supplied to the components so that
power will be supplied to the deck when it becomes
activated by the timer.
When using a new tape which has never been
recorded, be absolutely sure to press the rewind..
button to rewind the tape to its beginning, press the
record button to write the lead-in onto the tape, and
When proceeding with timer recording from any point
then set the deck to the recording standby mode.
along the tape, set the timer after having set the position
a
where the recording is to start using the append button.
Pe
.
elt takes a few moments for recording to begin after the
4
2.
fac LeveL
Adjust the recording
timer power has been switched on.
=x
level and recording
When setting the times on the timer, set the recording start
Bie
Ns
balance.
time on the early side to provide some leeway.
A
,
(This is not necessary
Depending on the status of the tape, the absolute time
¥
when recording digital
may not be written during timer recording.
input signals.)
eAfter timer recording has ended, return the timer switch to
paki
the OFF position.
Advertisement
Table of Contents
