Table of Contents
Advertisement
1D ifotie-lm [alelei am (-rere)eel elem @@L@@mE-\el-1-))
Writing the track numbers
If recording is started when a track number is
displayed, the track number can be written at that
time.
Writing the track numbers automatically
Check that the auto track
AUTO
number write Indicator Is
lighted.
The auto track number
writing mode is
established when the
power is switched on.
The auto track number writing function is operational only
for recordings from CDs, DATs and other DCCs. It may not
work on some models.
Writing the track numbers manually
During recording:
Check that the auto track
number write indicator has
WRITE
gone off.
Press this button where
the track number is to be
written. Each time it is
pressed, the track
numbers are written In
sequence.
If the play button is pressed after the pause button or
auto rec mute button was pressed during recording,
the track number is added at that position.
The track number display
|
can be checked by
| TRACK:
observing the track
number indicator.
Reference:
Only the start marker is written when the track numbers are
nat displayed but the track numbers can be added later by
renumbering. (See page 50.)
What is the "LEAD-IN"'
area?
Start of track 1
The count commences
from an absolute time
minus value.
of 0:00.
+
—>
>
Absolute time is
displayed as a
—0:10
G:00, 0:01, 0:02...
t
Leader
tape
section
leader tape section and start of the first track
where digital signals are written in order to
{
ensure that the digital audio signals will be
played back properly from the start of the first
track.
When the tape is rewound to its beginning, the
deck rewinds the tape as far as the leader tape
\
section where it is set to the recording standby
|
|
|
|
i
t
"LEAD-IN" is an area on the tape between the
|
mode, and then the LEAD-IN area extending for
about 10 seconds is automatically written onto
the tape.
After the LEAD-IN area has been written,
recording can be performed.
Advertisement
Table of Contents
