Technics RS-DC10 Operating Instructions Manual page 5

Accessories
Before proceeding to install and
connect the deck, be sure to
check that all the supplied
accessories are present and
accounted for. 7
LJ Stereo connection cables (x2)
[_] Remote contro! transmitter
(DC10/EURZK011D002)
(_] Batteries tor remote controller (x2)
ae
im DCC tape for recording (x1)
SS
[] Power plug adaptor (xt) .
(For areas except Continental Europe, United
Kingdom and Australia)
Before Use
(For areas except Continental Europe, United
Kingdom and Australia)
Be sure to disconnect the mains cord before adjusting
the voltage selector.
Use a minus (—) screwdriver to set the voltage selector
(on the rear panel) to the voltage setting for the area in
which the unit will be used.
(if the power supply in your area is 117 V or 120 V, set
to the "127 V" position.)
Note that this unit will be seriously damaged if this
setting is not made correctly. (There is no voltage
selector for some countries; the correct voltage is
already set.)
Note:
The configuration of AC power supply cord differs
according to area. -
(For areas except Continental Europe, United
Kingdom and Australia)
If the power plug will not fit your Household AC outlet,
use the power plug adaptor (included).