LG WSED7667M Owner's Manual page 83

global_main.book.book Page 83 Wednesday, February 8, 2023 4:52 PM
CAUTION
• Do not use oven cleaners. Commercial oven
cleaner or oven liner protective coating of any
kind should not be used in or around any part of
the oven.
• Clean only parts listed in the manual. Remove
the baking tray, deep baking tray, wire grill, all
cookware, aluminum foil or any other material
from the oven.
- If oven racks are left in the oven cavity during
the Pyrolysis cycle, they will discolor and
become difficult to slide in and out.
• The oven displays an error code and sounds
F
three long beeps during the Pyrolysis cleaning
process if it malfunctions in the Pyrolysis mode.
Switch off the electrical power to the main fuse
or breaker and have the oven serviced by a
qualified technician.
• If the Pyrolysis mode malfunctions, turn the
oven off and disconnect the power supply. Have
it serviced by a qualified technician.
• It is normal for parts of the oven to become hot
during a Pyrolysis cycle. Avoid pressing the
door, window or oven vent area during a
Pyrolysis cycle.
• Do not leave small children unattended near the
appliance. During the Pyrolysis cycle, the
outside of the oven can become very hot to
touch.
• If you have pet birds, move them to another well-
ventilated room. The health of some birds is
extremely sensitive to the fumes given off during
the Pyrolysis cycle of an oven.
• Do not line the oven walls, racks, bottom or any
other part of the oven with aluminum foil or any
other material. Doing so will inhibit heat
distribution, produce poor baking results and
cause permanent damage to the oven interior
(aluminum foil will melt to the interior surface of
the oven).
• Do not force the door open. This can damage the
automatic door locking system. Use care when
opening the oven door after the Pyrolysis cycle.
Stand to the side of the oven when opening the
door to allow hot air or steam to escape. The
oven may still be VERY HOT.
MAINTENANCE
NOTE
• The oven light cannot be turned on during a
Pyrolysis cycle. The oven light cannot be turned
on until the oven temperature has cooled below
250 ℃ after a Pyrolysis cycle is complete.
• Clean the frame of the oven and door with hot
soapy water. Rinse well.
• Do not clean the gasket. The fiberglass material
of the oven door gasket cannot withstand
abrasion. It is essential for the gasket to remain
intact. If you notice it becoming worn or frayed,
replace it by a service technician.
• It is normal for the fan to operate during the
Pyrolysis cycle.
• As the oven heats, you may hear sounds of metal
parts expanding and contracting. This is normal
and will not damage the oven.
• You may notice some white ash in the oven. Wipe
it off with a damp cloth or a soap-filled steel wool
pad after the oven cools. If the oven is not clean
after one Pyrolysis cycle, repeat the cycle.
• After a Pyrolysis cycle, fine lines may appear in
the porcelain because it went through heating
and cooling. This is normal and will not affect
performance.
• The Pyrolysis cycle cannot be started if the
Control Lock feature is active.
• Once the Pyrolysis cycle is set, the oven door
locks automatically. You will not be able to open
the oven door until the oven is cooled. The lock
releases automatically.
• After the oven is turned off, the convection fan
keeps operating until the oven has cooled down.
83