Honeywell BENDIX/KING KAP 140 Maintenance Manual page 46

3.3 NAVIGATING THE REMOTE TERMINAL INTERFACE (RTI) SCREENS
The following discussion of RTI screens assumes that a properly configured terminal is connected
to the RTI. If the RTI screen cannot be obtained by pressing the ENTER key or CTRL--W (screen
refresh), check the terminal connections and that the terminal is configured as described above.
The example screens shown throughout this discussion may
include sample data which will not necessarily be seen by the user.
3.3.1 MAIN MENU SCREEN
Upon initial power--up of the FCC, the RTI Main Menu screen will be displayed as shown in Figure
3--1. The Main Menu screen provides selections for entering diagnostics mode, displaying the
error log, displaying the software identification number, or configuring the system. The following
sections provide specific instructions on using these options.
Note that the built--in preflight test (PFT) mode must finish before these selections can be
accessed. This usually takes less than one minute after power up. After PFT is complete, pressing
the 'ENTER' key will refresh the Main Menu screen and the system mode displayed at the top of
the screen will change from "PFT" to "Normal Mode". This indicates that the options are now
available to use.
If the terminal is turned on after the power is applied, the terminal
screen will be redrawn when the 'ENTER' key is pressed. Whenever
a screen other than the Main Menu screen is active, the Main Menu
screen can be returned to by continually pressing the 'ENTER' key,
pausing long enough between key presses to allow a new screen to
be displayed on the terminal.
Revision 2, Dec/2002
CS:15574F02
BENDIX/KING
KAP 140
NOTE
System mode: PFT
KC 140 Flight Computer
-----------------------
D - Diagnostics
L - Error Log
S - Display SW ID
N - Installation
Press key for desired option :
FIGURE 3--1 MAIN MENU SCREEN
NOTE
Page 3--2