Honeywell BENDIX/KING KAP 140 Maintenance Manual page 104

ERR# TEXT MESSAGE(S)
DESCRIPTION OF ERROR
190 Error in Encoding Altimeter Input
The parallel altitude information from the altimeter is not a valid Gilham
code. The altimeter may be powered off or there may be a broken wire in the
harness. The Altitude ARM mode will be disconnected if this occurs.
191 Error in remote baro input
The remote baro input is outside the valid operating range. The KC 140 will
revert to using its baro select knob.
192 Error in pressure sensor input
The pressure transducer signal is outside the valid operating range. ALT ARM
mode, ALT hold mode, and AP mode will be disconnected if this occurs. Pitch
Axis operation will be disallowed until the pressure transducer signal is valid
again.
193 Erroneous Altimeter Reading
The software detected a greater than 100 foot change between samples of the gillham
altitude.
200 SREC upload memory overrun
This is a development mode error and should not occur in production units.
There was an error in the attempt to upload a new algorithm. The upload buffer
became full before the entire file was transferred.
201 SREC upload checksum error
This is a development mode error and should not occur in production units.
There was an error in the attempt to upload a new algorithm. The upload data
does not match the checksum in the file.
202 Invalid ECAL slot
This is a development mode error and should not occur in production units.
There was an error in the attempt to upload a new algorithm. An erroneous upload
buffer number was passed to the algorithm loader.
240 Acc Mon roll clutch eng failed
An attempt to engage the roll clutch during PFT failed. No current was sensed
in the roll clutch. This error code is not present in software flavors --0103,
and --0104. Pitch Axis operation will be disallowed.
241 Acc Mon pitch clutch eng failed
An attempt to engage the pitch clutch during PFT failed. No current was sensed
in the pitch clutch. This error code is not present in software flavors --0103,
and --0104. Pitch Axis operation will be disallowed.
Revision 2, Dec/2002
CS:15574F02.IDU
BENDIX/KING
KAP 140
POSSIBLE FAILED UNIT(S)
Altimeter, KC140
KC 140, Altimeter
KC 140
KC 140, Altimeter
KC 140
KC 140
KC 140
KC 140, KS 271C, harness wiring
KC 140, KS 270C, harness wiring
Page 5--14