Table of Contents
Advertisement
Inserting
a scene from a VCR - Insert Editing
(1) Set the POWER switch to VTR.
(2) On the VCR, locate just befbre the insert start point [a], then press n to set tile VCR
to tile playback pause mode.
(3) On your camcorder, locate tile insert end point [c] by pressing "4'4 or I_1_. Then
press II to set it to tile playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander.
Tlle ZERO SET MEMORY
indicator flashes and the end point of tile insert is stored in memory.
(5) On yore camcorder, locate tile insert start point [b] by pressing "<1"4, then press
• REC and the button on its right simultaneously to set your camcorder to tile
recording pause mode.
(6) First press II on tile VCR, and after a %w seconds press n on your camcorder to
start inserting the new scene.
Inserting automatically stops near" tile zero point on tile counter. Your camcorder
automatically stops. The end point [c] of the insert stored in memory is canceled.
5
r-,
5'
ZERO SET
MEMORY
To change
the
insert
end
point
Press ZERO SET MEMORY
again after step 5 to erase the ZERO SET MEMORY
indicator
and begin from step 3.
Notes
• Tile zero set memory
flmrtion
works only fur" tapes recorded
in tile Digital8 [) system.
• The picttn e and sound recorded
on the section between
the insert start and end points
will be erased when you insert the new scene.
When the inserted
picture is played back
Tile picture
may he distorted
at the end of the inserted
section.
This is not a
n-lalftmction.
To insert a scene without
setting
the insert end point
Skip step 3 and 4. Press • when you want to stop inserting.
63
Advertisement
Table of Contents
