Ferroli DIVATOP D C Instructions For Use, Installation & Maintenance page 45

DIVATOP D C
Installer menu [SERVICE]
After selecting the installer menu [Service], press the button
buttons and DHW to set the cell value, and the buttons
Confirm with the button
• [TSP] - Menu for modifying transparent parame-
ters
• [Test] - Activation of boiler Test mode.
• [OTC] - Setting of heating curves for adjustment
with external probe.
• [Zone] - Settings of heating curves of additional
zones.
• [Auto Setup] - This menu is used to activate cali-
bration. Visible only with parameter b12 set to 1.
Boiler information menu [Diagnostic]
This menu provides the information, in real time, of the various sensors present in the boiler.
To access it, press the button
EN
PASSWORD
0 0 0 0
fig. 15- Password entry
to access the installer menu[SERVICE] screen where the following menus are available:
from the main screen, select the item [Diagnostic] and confirm with the button
DIAGNOSTIC
CH 1 temp
CH 2 temp
DHW temp
Ext temp
Power
DHW flow
Water Pressure
Flame
fig. 17
cod. 3540000140 - Rev. 02 - 09/2023
. To continue, enter the password "1234". Use the
and heating to shift position (fig. 15).
PASSWORD
1 2 0 0
SERVICE
TSP
Test
OTC
Zone
Setup
fig. 16
27
°C
26
°C
25
°C
--
°C
--%
0,0
l/min
Ok
--
.
45