Installing The Plastic Wedges; Electrical Connection; Illumination Lamp - Grundig GSN 10621 X User Manual

If two coolers are to be
installed side by side,
C
there should be at least
4 cm distance between
them.
3.2 Installing the
plastic wedges
Plastic wedges are used to create
the distance for the air circulation
between the product and the rear
wall. Insert the 2 plastic wedges
onto the rear ventilation cover as
illustrated in the figure. To install
the wedges, remove the screws
on the product and use the screws
given in the same pouch with the
wedges.

3.3 Electrical connection

Connect the product to a grounded
outlet protected by a fuse
complying with the values in the
rating plate. Our company shall
not be liable for any damages that
will arise when the product is used
without grounding in accordance
with the local regulations.
12
•
Electrical connection
must comply with national
regulations.
•
Power cable plug must be within
easy reach after installation.
•
The voltage and allowed fuse or
breaker protection are specified
in the Rating Plate which is
affixed to interior of the product.
If the current value of the fuse
or breaker in the house does
not comply with the value in the
rating plate, have a qualified
electrician install a suitable
fuse.
•
The specified voltage must be
equal to your mains voltage.
•
Do not make connections via
extension cables or multi-plugs.
WARNING:
power cable must
B
be replaced by the
Authorised Service
Agents.
WARNING:
product has a failure, it
should not be operated
B
unless it is repaired by
the Authorised Service
Agent! There is the risk of
electric shock!

3.4 Illumination lamp

Do not attempt to repair yourself
but call the Authorised Service
Agent if the LED illumination
lamps do not go on or are out of
order.
Damaged
If the