Table of Contents
Advertisement
To Enter a Trip Start, with MARK TRIP START highlighted, press the "=" key.
If trip start is acknowledged by the data recorder, "TRIP START ENTERED"
will be displayed for 15 seconds and then the display will return to the Data
Recorder screen. In the unlikely situation that the data recorder is not
functioning properly "CANNOT ENTER TRIP START" will flash and then the
display will revert back to the Data Recorder menu.
If configured to do so, the System will prompt for entry of a customer
specific data protect PIN code before any data recorder print
functions can be used. If this code is not entered, all print functions
are locked out.
12.2
Print to Screen
PRINT TO SCREEN displays a graphical representation of the recorded data.
To display the data, highlight PRINT TO SCREEN, and press the "=" key.
Collecting Data, Please Wait
DOWN KEY = PREVIOUS DAY
EQUAL KEY = EVENT TOGGLE
Once the graphical display is presented, press the ▲ or ▼ key to move
through the recorded data, day by day. The data is presented with the left
horizontal axis as 00:00 (midnight) with 24 dividing lines representing the
hours of the day.
Press the "=" key to toggle the event codes on or off. When viewing events
with the event codes ON, the following acronyms will be displayed:
c = Door Close
d = Defrost start
e = Defrost end
f = Power down
62-11784
NOTE
UP KEY = NEXT DAY
EXIT
o = Door open
p = Power up
r = Real time clock change
t = Trip Start
22
SETPOINT
75
60
45
30
15
Time & Date
RAT
SP
SAT
EXIT
Advertisement
Table of Contents
