Table of Contents
Advertisement
SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the fi ve #8 x
3/4" Truss Head Screws (24), and carefully pivot off
the Motor Hood (62).
a
62
24
Next, locate the Reed Switch (125) and the Magnet
(127) on the left side of the Pulley (51). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in.
(3 mm). If necessary, loosen the #8 x 3/4" Truss
Head Screw (24), move the Reed Switch slightly,
and then retighten the Truss Head Screw. Reattach
the Motor Hood (see above), and walk on the
treadmill for a few minutes to check for a correct
speed reading.
Top
View
125
24
3 mm
24
24
24
51
127
30
b. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (A) on the back
edge of the console. Using a bent paper clip (B),
press and hold the reset button inside the opening,
and have a second person press the power switch
into the on position. Continue holding the reset
button until the console turns on. When the reset
operation is complete, the console will turn off and
then turn back on. If it does not, use the power
switch to turn the treadmill off and then on again.
Once the console turns on, check for fi rmware
updates (see HOW TO USE THE MAINTENANCE
SECTION on page 25). Note: It may take a few
minutes for the console to be ready for use.
b
B
A
Advertisement
Table of Contents
