Maintenance Intervals - Weh TK16 H2 Operating Instructions Manual

Î Observe the specified tightening torques and bondings during maintenance.
Î
Only apply pressure to the fueling nozzle when it is connected to the receptacle or
a WEH Service receptacle. For purging or other maintenance work such as leak
®
testing, connect the fueling nozzle to a WEH
Checking the leak rate on page 29).
Attention: If you apply pressure to the fueling nozzle without a service receptacle, the
fueling nozzle may be damaged. Therefore always use a WEH
9�2

Maintenance intervals

Î
Inspect the WEH
conditions, but at least every 3 months. After 20,000 cycles or 3 years at the latest,
depending on what happens first, starting from the date of delivery (invoice/ goods
issue date by WEH or the distributor), the WEH
maintenance.
These intervals can also be significantly shorter, which depends especially on your
individual application/use. Therefore, in case of abnormalities – especially during
regular inspection – send the WEH
If the WEH Product is not regularly inspected and sent to WEH for maintenance,
®
leakage may occur and under certain circumstances this may result in failures and/
or accidents.
Product at regular intervals depending on the respective operating
®
®
Service receptacle (see Chapter 11.
®
Product must be sent to WEH for
®
Product immediately to WEH for maintenance.
Operating instructions
Service receptacle.
®
MD-10286-L51-R1.0.0-07
AE
Page 21