Table of Contents
Advertisement
The electrical connections
WARNING
THIS APPLIANCE MUST
BE EARTHED.
The manufacturer declines any liability
should this safety measure not be
observed.
If the plug that is fitted to your
appliance is not suitable for your socket
outlet, it must be cut off and the
appropriate plug fitted.
The cut off plug should be disposed of to
prevent the hazard of electric shocks in
case it should be plugged into a 13 Amp
socket in another part of your home.
IMPORTANT
The wires in the mains lead are coloured
in accordance with the following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
If you fit your own plug the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, this is what you have to do:
Connect the green and yellow (earth)
wire to the terminal in the plug which is
marked with the letter «E» or the earth
symbol
, or coloured green, or
coloured green and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter «N» or coloured black.
Connect the brown (live) wire to the
terminal in the plug with the letter «L»
or coloured red.
The plug moulded onto the cord
incorporates a fuse, for replacement, use
a 13 Amp BS1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover 7carrier colour is the one
shown by the coloured insert at the base
of the plug.
The plug must not be used if the fuse
cover/carrier is lost A replacement
cover/earner must be obtained from
Zanussi Service Agents whose addresses
are listed on the attached «Zanussi
Service Agents Nationwide".
This appliance complies with E.E.C.
directive number 82/499 of 7.6.82
relative to radio interference suppression.
8
Advertisement
Table of Contents
