Wps - D-Link DWR-922 User Manual

Section 4 - Configuration
The Wi-Fi Protected Setup page allows you to create a wireless connection between your router and a device automatically by simply pushing a
button or entering a PIN code.

WPS:

Select whether you would like to Enable or Disable WPS features.
AP PIN: If you use Windows 7's Connect to a network wizard to do initial
configuration of the router, you will need to enter the WPS PIN/AP
PIN into the wizard when prompted. The factory default WPS PIN/
AP PIN is printed on a label located on the bottom of the router.
You can click the Generate New PIN button to change it to a
randomly generated PIN.
Config Mode: Select whether the WPS config mode should be set to Registrar or
Enrollee. In most cases, this should be set to Registrar so that you
can use WPS to connect new wireless clients.
Config Status: If this is set to CONFIGURED, the router will be marked as "already
configured" to computers that try to use WPS configuration, such
as Windows 7's Connect to a network wizard. You can click the
Release button to change the status to UNCONFIGURED to allow
for WPS configuration of the router.
If this is set to UNCONFIGURED, you can click the Set button to
change the status to CONFIGURED to block WPS configuration of
the router.
Disable WPS-PIN Enable this option to prevent clients from connecting to the router
Method: using the PIN method. If this option is enabled, clients must use
the push-button method to connect.
D-Link DWR-922 User Manual
WPS
30