Resetting The Device - QOLSYS IQ Dimmer-PG Installation Manual

Table 3: Device operations
Action
Long press the Dim Down
button
Double click the Dim Down
button
Short press the Dim Down
button
Long press the Dim Down
button
Short press the Dim Up button
Long press the Dim Up button
Additional behavior of the device
Behavior
Control the light on or off using the built-in
button
When enrolled
When power is removed from the device
When power is restored to the device
When communication is lost and then restored

Resetting the device

1. Press and hold both dim-up and dim-down buttons for at least 2 seconds. The LED turns
orange to indicate a long press.
2. Release briefly, then press and hold both buttons again for 5 seconds until the LED turns red
and flashes 3 times to indicate a device reset back to factory default.
Note: After a device is reset back to factory default, you must delete it from the panel
and re-enroll the device.
6 IQ Dimmer-PG Installation Guide
Status
On. Dim value greater than 0%
Off
On
Delay Off
Delay Off
Delay Off
Delay Off
Corresponding behavior
The IQ Panel updates the status within 10
seconds.
The IQ Panel registers the device as a PowerG
device.
The IQ panel updates the device status to
unreachable within 14 minutes.
The IQ panel automatically updates the device
status to normal within 5 minutes.
The IQ panel automatically updates the device
status to normal within 5 minutes.
D-308962 IQ Dimmer-PG Install Guide
Function
Decreases the light brightness
according to the dim value in
20% increments. The green
LED blinks when the dim value
reaches 0%.
Keeps the light Off.
The dimmer switchs the light
Off after a 5 minute delay as
hardware default.
Immediately turns the light Off
and cancels the delay off timer.
• Decreases the light
brightness in 20%
increments.
• Cancels the delay timer.
Immediately turns the light On
and cancels the delay timer.
• Increases the light
brightness in 20%
increments.
• Cancels the delay timer.