QOLSYS IQ Dimmer-PG Installation Manual page 4

Enrolling the device with Add PowerG
Before you begin: Ensure power is not connected to the device.
You can enroll the device in the IQ panel using the Add PowerG feature or scan the QR code on
the box. To enroll the device in the IQ panel using the Add PowerG feature, complete the following
steps:
1. On the IQ panel menu, select Settings > Advanced Settings > Enter Installer Code >
Installation > Devices > Automation > Add PowerG.
2. Enter the sensor id in the Sensor ID field or scan the QR code on the box label to enroll the
device.
3. Optional: Enter the PIN code on the product label for increased security during enrollment. The
device does not pair with the panel if you enter an incorrect PIN code.
4. Tap Pair.
5. Plug in and power on the device.
Result: The device enrolls successfully.
Considerations when you enroll a device
The following considerations apply when you enroll a device with PowerG or when you enroll a
device with Auto Learn enroll.
• If the buttons remain pressed after the light is turned off, the device returns to low-power
mode.
• If the connection is successful, the PowerG signal strength displays on the device and
the enrolled status on the control panel. For more information, see
configuration.
• If the connection fails, a Not enrolled status indicates on the control panel.
• The IQ Dimmer-PG enrolls as two individually controlled devices.
Checking the PowerG signal strength of the device
1. Ensure that the IQ Dimmer-PG is powered on.
On the IQ panel, tap Settings > Advanced Settings > Enter Installer
2.
Code > Installation > System Tests > PowerG Test > Run
PowerG signal strength indication
Signal strength
Strong
Good
Poor
4 IQ Dimmer-PG Installation Guide
LED indication
LED turns green and flashes 3 times
LED turns orange and flashes 3 times
LED turns red and flashes 3 times
D-308962 IQ Dimmer-PG Install Guide
LED indication and