Table of Contents
Advertisement
Callout
7
8
3.
Mount the dimmer with the screws and attach the faceplate. If you are using an electric
screwdriver, set the torque it to 1.2 Nm of torque to avoid overtightening the screws.
Figure 4: Mounting the device
4.
Turn power on at circuit breaker.
5.
Reinsert the air gap onto the dimmer.
Enrolling the device with Auto Learn Enroll
Before you begin: Ensure power is connected to the device.
1. On the IQ panel menu, select Settings > Advanced Settings > Enter Installer Code >
Installation > Devices > Automation > Auto Learn Devices.
2. Press and hold the dim up and dim down buttons until the LED turns orange for 2 seconds.
3. Release the buttons, and the LED turns off. The device enters enrollment mode, and the panel is
notified of the device initiating enrollment.
4. When the device is recognized, tap OK when the pop-up window appears. Enter the device
details in the next configuration pop-up window.
5. Optional: Enter the PIN code on the product label for increased security during enrollment. The
device does not pair with the panel if you enter an incorrect PIN code.
6. Tap Pair.
7. If the device does not automatically enroll, perform a factory reset as indicated in the
the device
section of the user manual.
Result: The device enrolls successfully.
Terminal screw marked white
Terminal screw marked black
D-308962 IQ Dimmer-PG Install Guide
Resetting
IQ Dimmer-PG Installation Guide
3
Advertisement
Table of Contents
