Table of Contents
Advertisement
Resetting the device
1.
Press and hold both on and off buttons for at least 2 seconds. The LED turns orange to
indicate a long press.
2.
Release briefly and press and hold both buttons again for 5 seconds until the LED turns red
and flashes 3 times to indicate a back to factory default reset.
Note: After a device is reset back to factory default, you must delete it from the panel
and re-enroll the device.
Troubleshooting
WARNING: The wiring should only be changed in accordance with applicable electrical codes
and regulations in your region.
WARNING: Only a qualified professional should attempt to change electrical wiring.
Light flickering
•
The light needs a better connection.
•
Wires need to be secured firmly under the terminal screws of IQ Power Switch-PG.
Light does not turn on and LED indicator does not turn on
•
Check if the circuit breaker or fuse has tripped.
•
Check if the light is burned out or if the light's neutral connection is not wired correctly.
Unable to control the lights remotely
•
Check if the IQ Power Switch-PG is connected to the IQ panel and ensure the wiring is correct.
Specifications
Frequency
Protocol
Maximum noise
Maximum load
Standby power consumption
Power supply
Maximum current
Wiring
Humidity
Operating temperature range
Storage temperature range
Device weight
6
IQ Power Switch-PG Installation Guide
912-919 MHz
PowerG
24dB at 20cm
Incandescent 600W, CFL/LED 300W
<1W
120V at 60Hz
5A
Direct wire connection, wire gauge 16 AWG
0 to 85%, non condensing
0°C to 40°C or 32°F to 104°F
-20°C to 60°C or -4°F to 140°F
116g
D-308963 IQ Power Switch-PG Install Guide
Advertisement
Table of Contents
