Table of Contents
Advertisement
English
Troubleshooting
Guide
Disc Control Mode
PROBLEM
POSSIBLE CAUSE
SOLUTION
The disc control mode cannot
No cable has been connected to the disc changer input
Connect the cable to the dise changer input terminal on the
be selected.
terminal on the unit.
unit.
The O-N selection switch of the disc changer is not set
Set the O-N selection switch to "O"" position.
properly.
The specitied disc does not
The specified CD is quite dirty.
Clean the CD.
play, but another one plays
instead.
The CD is upside-down.
Load the CD with the labeled side up.
The disc is loaded in a different slot fromm that specified.
Fject the disc magazine and check the number for the
specified disc.
The disc is severely scratched.
Try another disc instead.
The sound skips.
Something is touching the disc changer.
Remove whatever is touching it.
The CD is scratched or dirty.
lf skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
The display shows that the
The computer chip in the unit is not functioning normally.
Press the reset button on the unit {see p. 6}.
changer is being played, but no
sound can be heard.
The specified track will not
Random play or magazine random play has been selected.
Turn off random play or magazine random play.
play.
;
The
acti
Ejec
Nol
No C¢
Erro
Blan
No T
Errot
Errol
Advertisement
Table of Contents
